Using a Condensate Return Calculator to Size Pumps and Receivers Skip to content

Engineering

Using a Condensate Return Calculator to Size Pumps and Receivers

Amit Kumar 2 min read

Condensate return pumps move hot condensate from steam equipment back to the boiler room. Undersize them and condensate backs up into heat exchangers and coils; oversize them and they short-cycle and wear out early. A condensate return calculator takes much of the guesswork out of sizing.

What the calculator needs

  • Load: in boiler horsepower, EDR, lbs of steam per hour, BTU/hr or MBH

  • Lift: the vertical distance the pump must push condensate

  • Back pressure: pressure in the return line or receiving tank

  • Friction loss: based on pipe length, diameter and fittings

What it gives you

From those inputs a calculator estimates the required flow in GPM, a suitable receiver size in gallons, and the discharge pressure the pump must develop. Many tools also show results for simplex and duplex pump arrangements.

Rules of thumb engineers still check

  1. Size pumps with margin above the condensing rate to handle start-up loads.

  2. Keep pipe velocity reasonable to limit friction loss and noise.

  3. Watch condensate temperature, since hot condensate reduces available NPSH.

  4. Confirm the receiver gives enough storage between pump cycles.

Why it matters

Returning condensate saves water, treatment chemicals and the energy needed to heat cold make-up water. A correctly sized return system keeps steam equipment draining properly and protects the boiler.

Try it

Skidmore Pump offers a free condensate return calculator along with boiler feed, vacuum and NPSHa calculators to help match pumps and receivers to your load.

0 Comments

No comments yet. Be the first to respond.